Vishay 2310 User Manual Page 3

  • Download
  • Add to my manuals
  • Print
  • Page
    / 8
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 2
Micrel, Inc. MIC2310 Evaluation Board
July 2008
3
M9999-070808-A
condition lasting longer than the programmed t
POC
or immediately for an overcurrent that exceeds the
secondary overcurrent threshold.
3) The HW_FLT signal will assert when a shorted
R
SENSE
is detected or a damaged power MOSFET
is detected by either a D-S short or D-G short
during startup.
Jumper Options
Jumper Label Position Function Factory Setting
JP1 VISS Shorted
Open
Provides an analog output level that is proportional to the
steady-state load current. This output is often fed through an
ADC for data conversion back to the system controller to
manage the power allocated for the downstream modules.
Shorted
JP2 ENABLE Shorted
Open
ON/OFF control pin used to turn on the GATE output. Shorted
(Ground)
JP3 S0_SEL Shorted
Open
Secondary Overcurrent Threshold Set (Input) Shorted
(High)
JP4 S1_SEL Shorted
Open
Secondary Overcurrent Threshold Set (Input) Open
(Pull-Down to
Ground)
JP5 SCR_SEL
(DISCH)
Enabled
Ground
Control for enabling a fast-responding (crowbar) circuit for the
output bulk capacitance to quickly discharge to ground.
Enabled
JP6 RETRY_SH
(CRETRY)
Shorted
Open
Output auto-retry or latch-off configuration upon an overcurrent
fault occurrence.
Shorted
(Latch-off)
JP7 LDO_SEL Shorted
Open
Power supply input to an LDO that powers the logic output
signal circuitry.
Shorted
JP8 SLEW
(CSLEW)
Shorted
Open
Output slew control that is used to adjust the inrush current
profile via dI
DRAIN
/dt if enabled (shorted) or via dV
GATE
/dt
Shorted
(dV
GATE
/dt)
JP9 HWF_DRV Shorted
Open
Drive circuit to an LED for HW_FLT indication Shorted
JP10 PG_DRV Shorted
Open
Drive circuit to an LED for “Power-is Good” indication Shorted
JP11 IFLT_DRV Shorted
Open
Drive circuit to an LED for an overcurrent fault indication Shorted
Page view 2
1 2 3 4 5 6 7 8

Comments to this Manuals

No comments